Dryer for Medical equipments, Autoclave Manufacturer in chennai, Sterilizer Supplier in chennai, medical equipments for sales in bangalore

Reico offers modern Drying Plants for Dairy, Food, Chemical and pharmaceutical industries based on indiginously developed technology and most economic Dryers matching the specific requirements.

Drying oven is fabricated out of rigid angle iron frame with double walled panels insulated with best quality compressed fibre glass and with a rigid door fitted with strong hings and best choosen locking arrangement. A control is fixed in front of the oven to facilitate the operation easily. It has large working space and is available in good finishing in synthetic enamel colour. Inner walls are painted with heat resistant paint to resist temperature up to 300 degree

The Drying ovens are electrically heated and thermostatically controlled. It is fitted with timer to facilitate working day and night. Dryers are well accepted for fast economical drying of powders, bottles & other materials.

A highly effective recirculating air system is provided. The filtered air, heated electrically , is recirculated with fresh air in selected proportions for optimum drying. Uniform air circulation, controlled temperature , sturdy construction and large working space are the valuables of the oven which is suitably designed to cover wide temperature range . loading and unloading is faster and simple .In Higher capacities trays trolley rolls in and out of the chamber. For continuous operation a spare trolley can be had for loading while the drying cycle is taking place.

Dial thermometer and a thermostat/digital temp controller with time switch are supplied to facilitate working day and night.

REICO Spray dryers are relatively simple in operation which accept feed in fluid state and convert it into a dried particulate form by spraying the fluid into a hot drying medium.

Feed Atomisation is done using High Pressure Nozzle, High Pressure Air, or Two Fluid Nozzles. The heating method of drying air can be of either steam coils or thermic fluid or Air Heater according to the service conditions available. The hot air is distributed into the chamber from top by an Air Disperser.

The fines produced is taken out from the top/center along with air to a Cyclone Separator & separated, final powder being collected at the bottom. Additional systems like fines recycling into the chamber for agglomeration, powder cooling, conveying , storage & bagging are optional.

A continuous flow of material is dried by contact with hot air while being transported by the air stream. A single exhaust fan is used to induce the flow of gas through the heater, up take pipe, horizontal duct & duct collector separator. If required a cage mill fan can be used as a lump breaker to disintegrate larger agglomerates. For dust collection and separation cyclones or bag filters are used. In a Flash Dryer, material is in intimate contact with the gas stream for a very short time which makes it ideally suitable to remove free moisture with a very small residence time.

In direct heat Rotary Dryers a continuous feed of wet particulate material is dried by contact with heated air, while being transported along the interior of a rotating cylinder, with the rotating shell acting as the conveying device and stirrer.

REICO offers Rotary Dryers in co-current (parallel) and counter-current operation. In the former the wet material is exposed to the hottest air which enables heat sensitive or sticky materials to be dried successfully. In counter-current operation dried material is exposed to the hottest air helping to achieve very low moisture content. The hot gases may enter at the temperature of 1650ºC.

Stream tube dryers is one of the indirect heat Rotary Dryers, contain rotating shell, rows of Steam Tubes arranged in concentric circles and extended throughout the length of the Dryer.

Steam Tubes are designed to transfer heat from steam to the material being dried. REICO offers tubes with or without fins according the design specifications. The tubes and radial flights together serve to agitate the material.